Professional PCB manufacturing and assembly
Building 6, Zone 3, Yuekang Road,Bao'an District, Shenzhen, China


EMC layout design of PCB

Separate the low level analog circuit from the digital circuit to avoid the common impedance coupling between the analog circuit, the digital circuit and the common circuit of the power supply.

Key points of EMC design for multilayer PCB board design

PCBS with multiple layers are often used in high-speed, high-performance systems, where the multiple layers are used for direct current (DC) power supplies or ground reference planes.

Three elements of EMC suppression in PCB

With both analog and digital functions of the circuit board, analog and digital are usually separated, only connected at the power source.

What should we pay attention to in the design of multilayer PCB routing with EMC technology

Although the decoupling capacitor can be placed near the through-hole, it is rendered useless at high frequencies due to the lead and through-hole inductance. Such routing will increase the area of signal ring and reduce the current radiation unfavorably.

In high speed PCB design, designers should consider from what aspects EMC, EMI rules?

When selecting the driver chip, in addition to ensuring that it basically matches the load and that the signal edge meets the requirements (generally, the clock is an effective signal along the clock), the time delay of the clock in the driver chip should

How to meet EMC requirements as far as possible without causing too much cost pressure?

That is to say, the digital-to-analog undivided way can only be used when the analog circuit area is far away from the digital circuit area that generates large noise.

Precautions for emi emc pcb layout

What problems should we pay attention to in PCB laminated design? Let a professional engineer tell you. Two rules must be followed in the design of lamination

EMC problem What are the factors in PCB design?

Factors related to EMC issues in PCB design: 1. System design: 2. Structural impact: 3. Cable influence: 4. Component selection: 5. Related to SI/PI simulation: 6. Grounding, 7.PCB design relationship, 8. Software anti-jamming technology: 9. Shielding: 10

The six-layer PCB design is in line with EMC design

Solutions to impedance discontinuity problems in PCB design: 1. Gradient line, 2. Corner, 3. Large pad, 4. Through hole, 5. Through hole coaxial connector

Power problems in EMC design

The other is ground (or low potential) noise, that is, ground noise caused by the potential difference between ground wires in various parts of the system or by the presence of ground impedance.

EMC considerations for PCB design

In practical EMI shielding, the electromagnetic shielding efficiency depends largely on the physical structure of the chassis, namely, the continuity of conduction. The seams and openings in the chassis are leakage sources of electromagnetic waves.

Influence of slotting on EMC performance of PCB board

The generation of grooving can be summarized into the following two cases :1. Grooving caused by power/ground plane segmentation; 2.the through hole is too dense to form grooves.

Just upload Gerber files, BOM files and design files, and the KINGFORD team will provide a complete quotation within 24h.