Development of FPC flexible circuit board
With the continuous advancement of information and intelligent construction, the market demand for flexible circuit boards will be more and more large.
With the continuous advancement of information and intelligent construction, the market demand for flexible circuit boards will be more and more large.
The market share of FPC is increasing with the development of miniaturized and portable electronic products. However, FPC may have defects such as open circuit, short circuit and line width discrepancy in the process of processing, feeding and mounting.
The Circuit Board can be called Printed Circuit board or Printed circuit board, the English name is (Printed Circuit Board) PCB, (Flexible Printed Circuit board) FPC circuit board.
Automatic soldering machine for PCB circuit board soldering to provide technical support, however, the corrosion of PBC circuit board has been plagued by automatic soldering merchants.
Not only will you save money and move faster, but you'll also help you say "no" to tempting foods that may not be part of your diet. Preparing such written plans can help any project we are involved in. In the electronic field, these plans are c...
The next stage is product implementation. At this stage, product documentation is collected and compiled, including all manuals, catalogs, and related product documentation.
The challenge for the flexible circuit industry is to take advantage of its technological advantages and stay abreast of computers, telecommunications, consumer demand, and dynamic markets.
Solder paste is printed on the circuit board and then the electronics are connected to the circuit board by reflow soldering. This is the most common method in the electronics manufacturing industry, but in order to more accurately apply the solder paste
In order to meet customer requirements, the pass-through hole plugging process is varied, the process is particularly long, the process control is difficult, often in hot air leveling and soldering experiment oil loss; Oil explosion after curing.
With the appearance of 100 megabit bus, when the signal edge rate reaches picosecond level, the system performance depends more on the front-end design, requiring accurate timing analysis and calculation at the beginning of design. Timing analysis and sig
It has been proved that the reliability of electronic equipment will be adversely affected even if the circuit diagram is designed correctly and the printed circuit board is not designed properly.
With the development of the electronic industry, the integration degree of electronic components is getting higher and higher, and the volume is getting smaller and smaller, and the BGA type package is widely used.