Professional PCB manufacturing and assembly
Building 6, Zone 3, Yuekang Road,Bao'an District, Shenzhen, China
PCB Design
PCB Design
What are the tips for PCB wiring?
Hey 0 Comments

What are the tips for PCB wiring?

There is an old saying that PCB design is 90% layout and 10% wiring. So, what are the tips for PCB wiring?

1. Don't rely on your automatic wiring device

Almost all PCB design software includes a tool called an autocabler, but an autocabler will never replace itself in wiring and should only be used for several reasons, including:

Be precise. After all the components have been placed, you can use an auto-route to see the level of completion achieved.

Bottleneck. You can also use the auto-route to discover bottlenecks and other critical connection points that you may not have seen during component placement.

Inspiration. Use the auto wiring device as a source of inspiration to learn how to wire traces that you can't do.

In addition to the above reasons, it is recommended not to rely on automatic wiring to complete all the wiring on the PCB circuit board layout.

2. Understand the manufacturer's specifications

Before you begin laying copper wiring, call or email the customer and ask if they have any specific requirements for minimum wiring width, spacing, and the number of layers that can be handled. By knowing this information up front, you can set the wire width and spacing values in the design rules, rather than having to reroute the entire board layout.

3. Find the trace width

To determine the thickness of the line, you can use a handy line width calculator like Advanced Circuit, which will allow you to plug in the estimated current and thickness and get the line width value in exchange for the inner and outer layers.

4. Leave enough space between the tracks

Be sure to leave enough space between all the wiring and pads of the PCB layout. It is recommended to always leave a gap between 0.007 "and 0.010" between all adjacent pads on the board and the wiring.

PCB board

5. Use capture grids to make your job easier

It is recommended to set the capture grid spacing to 0.050 inches during wiring. When you need to design tightly spaced connections between components, you can also set the alternate spacing to 0.025 inches.

6. Avoid using a 90-degree cable Angle

When the circuit board has a bundle of sharp right-angled turns, the outer corner of that 90-degree Angle may be etched narrower than the standard line width, resulting in a short circuit. As a solution to this problem, try using a 45 degree angular trace.

7. Leave a space between the cable and the mounting hole

When using mounting holes, always remember to leave space beyond the physical dimensions of the mounting holes to prevent them from being affected by other components and nearby marks.

8. Always create a ground cable

There must be a common ground on the PCB board because it provides the same reference point for measuring voltage for all wires. Once the grounding layer is added, simply connect all the components that need to be grounded through the through-hole.

9. Expand power supply and ground wiring

Both the power supply and ground wiring will flow more current, and if you don't make them travel wider than usual, this could eventually burn the wires and damage your device and circuit board.

10. Use through hole heat dissipation

The through-hole is ideal not only for providing electrical connections between layers, but also for transferring heat from one side of the plate.

Just upload Gerber files, BOM files and design files, and the KINGFORD team will provide a complete quotation within 24h.