Look at the common impedance and suppression of advanced PCB design

PCB common resistance interference is caused by a large number of ground wires. When two or more circuits share a section of ground wire, different circuit currents will produce a certain voltage drop on the shared ground wire, which will affect the circuit performance after being amplified; When the current frequency is very high, it will produce a lot of inductive reactance and cause PCB circuit interference.

To suppress common impedance interference, the following measures can be taken:

(1) One point grounding

Several grounding points of unit circuits at the same level shall be concentrated as much as possible to prevent AC signals of other circuits from entering the same level, or AC signals of the same level from entering other circuits. It is applicable to low frequency circuits with signal operating frequency less than 1MHZ. If the operating frequency is 1-1OMHz and one point grounding is adopted, the length of ground wire shall not exceed 1/20 of the wavelength. In a word, one point grounding is the basic principle to eliminate the common impedance interference of ground wire.

(2) Nearby multipoint grounding

There are a large number of public ground wires distributed on the PCB at the edge of the board, and they present a semi closed loop (to prevent magnetic field interference). Circuits at all levels are grounded nearby to prevent the ground wire from being too long. It is applicable to high frequency circuits with signal operating frequency greater than lOMHz.

(3) Bus bar grounding

The bus bar is made of silver plated copper foil, and the ground wires of all integrated circuits on the PCB are connected to the bus bar. Busbars have low impedance characteristics of strip symmetric transmission lines. In high-speed circuits, they can improve signal transmission speed and reduce interference

(4) Large area grounding

In the high-frequency circuit, all unused areas on the PCB are laid as ground wires to reduce the inductive reactance in the ground wire, thus weakening the high-frequency signal generated on the ground wire and shielding the electric field interference.

(5) Bold grounding wire

If the PCB grounding wire is very thin, the grounding potential will change with the change of current, causing the timing signal level of the PCB equipment to be unstable and the anti noise performance to deteriorate, and its width should be at least greater than 3mm.

(6) Ground wire separation of D ／ A (digital ／ analog) circuit

The ground wires of the two circuits are independent of each other, and then connected with the ground wire of the power supply terminal respectively to suppress their mutual interference.